BALLOON HI FLOAT GEL (HAPPY FLOAT)

Description

Benefits & Uses

• Extended Flight Time: Increases the standard 12-inch balloon float time from a few hours to 1 day depending on ambient temperature.
• Pre-Party Preparation: Allows event decorators and hosts to inflate balloon clusters or bouquets a full day or two in advance.
• Glitter & Confetti Adhesive: Acts as an internal glue, allowing decorative confetti or glitter to stick evenly to the balloon walls.
• Safety: Formulated as a safe, non-toxic, and biodegradable liquid solution.

Step-by-Step Instructions

1. Prep the Bottle: Remove the standard cap from your Happy Float bottle and firmly screw in the included pump nozzle.
2. Inject the Gel: Insert the nozzle deep into the opening of the uninflated latex balloon. Dispense 1 to 2 small pumps (roughly 0.9 grams) directly into the base of the balloon. Tip: Avoid getting the gel on the balloon neck, which makes it slippery and difficult to tie.
3. Massage Thoroughly: Rub and massage the exterior of the balloon for a few seconds to distribute the gel evenly across the internal walls. Keep the neck elevated to avoid spilling.

4. Inflate Immediately: Inflate the balloon with helium until it reaches its full, standard pear shape. Do not under-inflate, or the balloon may become too heavy to float.
5. Allow to Dry: Let the balloon sit in normal room temperature for 1 to 2 hours to allow the liquid film to completely dry and set into a protective shield. Avoid packing them into transport bags until they are fully dry.

Important Restrictions

• Latex Only: This product is exclusively meant for latex balloons. Do not use it on foil or Mylar balloons.
• Helium Required: The gel itself does not make balloons float; it is simply a preservative coat. You must still inflate the balloon with separate helium gas.
• Environmental Sensitivities: High humidity, direct sunlight, and extreme heat or cold can drastically reduce the drying efficiency and overall float times.